SN7476 Pin Configuration
Pin Number Pin Name Description 5 Vcc Powers the IC typically with 5V 13 Ground Connected to the ground of the system JK Flip Flop – 1 / JK Flip Flop – 2 1,6 Clock-1/ Clock-2 These pins must be provided with clock pulse for the flip flop 2,7 Preset-1 / Preset-2 When Preset is high the flip flop will set Q=1 and not Q=0 3, 8 Clear-1/Clear-2 When Clear is high the flip flop will set Q=0 and not Q=1 12,16 K-1/ K-2 Input pin of the Flip Flop 4,9 J-1 / J-2 Another Input pin of the Flip Flop 10,14 Q-1(bar) / Q-2 (bar) Inverted output pin of Flip Flop 11,15 Q-1 / Q-2 Output Pin of the Flip Flop
- Dual JK Flip Flop Package IC
- Positive edge triggered Flip-Flop
- Operating Voltage: 4.5V to 5.5V
- Input Rise time at 5V : 16 ns
- Input Fall time at 5V : 25 ns
- Minimum High Level Input Voltage: 2 V
- Maximum Low Level Input Voltage: 0.8 V
- Available in 14-pin PDIP, GDIP, PDSO packages
Where to use 7476 JK Flip-Flop
The SN7476 is a dual in-line JK flip flop IC, i.e. it has two JK flip flops inside it and each can be used individually based on our application. The term JK flip flop comes after its inventor Jack Kilby. The JK flip flops are considered to be the most efficient flip-flop and can be used for certain applications on its own. The flip-flops are also called as latching devices meaning it can remember one single bit of data and latch the output based on it, due to this property they are commonly used as shift registers, control registers, storage registers or where ever a small memory is required. More than one Flip Flop can be used in series to act as an EEPROM for holding small amount of data. The JK flip flop is considered to be more suitable for practical application because of its truth table that is the output of the flip flop will be stable for all types of inputs.
So if you are looking for a IC for latching purpose or to act as a small programmable memory for you project then this IC might be the right choice for you.